Sharp MX-M202D Operation Manual page 97

Problem
The transmitted image is
distorted.
White or black lines
appear in the transmitted
image.
Transmission does not
take place at the specified
time.
Printing does not take
place after reception.
A received fax prints out
blank.
The received image is
faint.
The received image is
distorted.
A dial tone is not heard
through the speaker.
The machine does not
ring.
Dialling is not possible.
Check
Were line conditions poor
due to thunder or another
reason?
Were the resolution and
exposure settings
suitable?
Is the document glass or
the scanning glass for the
SPF/RSPF (the long,
narrow glass) dirty?
Is the machine's clock set
to the correct time?
Does an error message
appear regarding adding
paper, replenishing toner,
or a misfeed? (This means
that printing is not
possible.)
Is forwarding (Inbound
Routing function) selected
in the Web page for a
received fax?
Was the wrong side of the
original scanned in the
transmitting machine?
Is the original faint?
Were line conditions poor
due to thunder or another
reason?
Is the volume set to "low"?
Has the ringer volume
been turned off?
Is the telephone line
properly connected?
If an extension phone is
connected to the machine,
has the "EXTENSION TEL"
setting been enabled?
Solution
Try the transmission
again.
Check the resolution and
exposure settings.
Clean the document glass
or the scanning glass for
the SPF/RSPF.
Set the clock to the correct
time.
Restore printing capability
as instructed by the
display message. Printing
will begin.
If you need to print a
received fax, ask your
administrator.
When the Inbound Routing
function is enabled in the
Web pages, received faxes
are automatically forwarded
to a specified address. If
"Print at Error" is selected
when Inbound Routing is
enabled, received faxes will
only be printed when an
error occurs.
Check with the operator of
the transmitting machine.
Ask the other party to
re-send the fax using a
suitable exposure setting.
Ask the other party to
send the fax again.
Set the speaker volume to
"middle" or "high".
Set the ringer volume to
"low", "middle", or "high".
Check the connections.
Enable this setting.
TROUBLESHOOTING
Page
–
"SELECTING
RESOLUTION AND
EXPOSURE SETTINGS"
on page 14
"ROUTINE
MAINTENANCE" in the
Operation Guide for the
machine
"DATE & TIME SET" on
page 104
"WHEN AN ALARM
SOUNDS AND A
WARNING MESSAGE IS
DISPLAYED" on page 92
–
–
–
–
"SPEAKER VOLUME" on
page 101
"SPEAKER VOLUME" on
page 101
"Line connection" on page
4
"EXTENSION TEL" on
page 102
95
7