Sharp MX-M202D Operation Manual page 79

10
Select the program that you wish to
store with the [ ] or [ ] key.
• A transmission method, cover sheet/message,
resolution/exposure settings, dual pages, sender's
name, and transmission settings can be stored. A
transmission method must be stored. The storing
procedure cannot be completed unless a
transmission method is stored.
• For the procedures for selecting each of the settings,
refer to the explanations of the settings.
• To cancel a setting selection, select the setting that
you wish to cancel and then press the
• Some settings cannot be used in combination with
others. If you select a prohibited combination of
settings, a message will appear in the display.
11
To continue selecting another setting,
press the [OK] key.
When you have finished selecting settings, press the
[START] key ( ). You will return to step 8. If you wish
to store another program, repeat steps 8 to 11. To exit,
press the [BACK] key in step 8.
You can check the contents of a program
Note
(transmission type, destination) by printing
the "PROGRAM LIST" (page 85).
[EDITING PROGRAMS]
If you need to edit a previously stored program, follow
these steps.
6
Select the program that you wish to
edit with the [ ] or [ ] key.
PQ
DED COPY
LEX SCAN
LEX SCAN
ACC
If not all letters of the program name appear, press the
key to display all letters. Press the
again to return to the original screen.
7
Press the [OK] key.
GHI
BACK OK
PQRS
PROGRAM
TX TYPE
SENDING MENU
[ ]:CANCEL
[START]:ENTER
key.
PROGRAM
XXXXXX
— — — — — —
— — — — — —
[#]:LIST DETAIL
key once
8
Edit the program name (see
"ENTERING CHARACTERS" on page
86).
• See step 8 of "STORING A PROGRAM".
• If you do not wish to edit the program name, go
to the next step.
9
Press the [OK] key.
10
Select the stored setting that you wish
to edit with the [ ] or [ ] key.
• See steps 10 and 11 of "STORING A
PROGRAM".
• If you do not wish to edit the stored settings,
press the [START] key (
[BACK] key to exit.
[DELETING PROGRAMS]
Before deleting a program, print the "PROGRAM LIST"
to check the contents. (Page 85) To delete a
previously stored program, follow these steps:
6
Select the program that you wish to
delete with the [ ] or [ ] key.
PQ
DED COPY
LEX SCAN
LEX SCAN
ACC
If not all letters of the program name appear, press the
key to display all letters. Press the
again to return to the original screen.
7
Press the [OK] key.
GHI
BACK
OK
PQRS
8
Select "DELETE" with the [ ] or [ ]
key.
9
Press the [OK] key.
Return to step 6. To delete another program,
repeat steps 6 through 8. To exit, press the
[BACK] key.
PROGRAMMING
) and then press the
PROGRAM
XXXXXX
— — — — — —
— — — — — —
[#]:LIST DETAIL
key once
77
6