(as of August 2017)
(Available models differ according to region.)
CAN ICES-3 (A) / NMB-3 (A)
Thank you for purchasing a SHARP product.
Before using the product, please be sure to read this operation manual carefully. Before using the product, be sure to read and understand the
"SAFETY PRECAUTIONS" in the operation manual of the LCD MONITOR. After reading the manual, keep it in a convenient location where it
can be accessed at any time.
As for how to use the product, refer to the manual of the LCD MONITOR.
- This product was shipped after strict quality control and inspection; however, if breakage or a malfunction should be found, contact your
SHARP dealer or your nearest customer contact.
- Please understand that SHARP CORPORATION bears no responsibility for errors made during use by the customer or a third party, nor for
any other malfunctions or damage to this product arising during use, except where indemnity liability is recognized under law.
- This product and its accessories may be upgraded without advance notice.
To aid reporting in case of loss or theft, please record the
product's model and serial numbers in the space provided.
The numbers are located in the rear of the product.
FCC Regulations state that any unauthorized changes or modifi cations to this equipment not expressly approved by the
manufacturer could void the user's authority to operate this equipment.
This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
Changes or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of this device.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has
very low levels of RF energy that are deemed to comply without testing of specifi c absorption ratio (SAR).