Using Broadcast Transmission - Sharp MX-M202D Operation Manual

ADVANCED TRANSMISSION METHODS

USING BROADCAST TRANSMISSION

1
Perform steps 1 to 4 of "BASIC
PROCEDURE FOR SENDING FAXES"
(page 17).
2
Press the [BROADCAST] key.
R SELECT COPY RATIO AUTO IMAGE OUTPUT 2-SIDED
OLUTION ADDRESS FORMAT ORIGINAL SIZE DUPLEX
ADDRESS DUPLEX
OLUTION BROADCAST ORIGINAL SIZE
The destination selection
screen appears.
3
Enter a full fax number with the
numeric keys or press an auto-dial
key (Rapid key, Speed Dial number, or
group key) to select the first
destination. (Page 19)
To clear a mistake when
entering a full number with the
WXYZ
numeric keys, press the [C] key
to clear one digit at a time.
26 27 28
A B C
31 32 33
F G H
36 37 38
A destination selected with a Rapid key, Speed Dial
number, or group key is indicated by an icon and a
number. To clear an entry, press the [C] key.
32
ENTER RX STATION
:
4
Press the [OK] key and then select the
next destination by entering a full fax
number or pressing an auto-dial key.
After entering a full number with
the numeric keys, press the
GHI
BACK OK
[OK] key to complete the entry.
If you pressed an auto-dial key
PQRS
in step 3, it is not necessary to
press the [OK] key. You can
immediately press another auto-dial key for the next
destination. Repeat steps 3 and 4 to select the
remaining destinations.
• If you need to delete a number for which
Note
entry has already been completed by
pressing the [OK] key, use the [
key to select the number and then press
the [C] key.
• If the selected destinations exceed the
display range of the message screen,
press the [ ] or [
and check the destinations.
• Destinations can also be selected using
the address directory and the [REDIAL]
key. Note, however, that the [REDIAL] key
can only be used to select the first
destination (it must be used before any
other destinations are selected).
• If you use two group keys that have 50
stations each, the total number of
destinations entered will be 100.
5
Continue from step 6 of "BASIC
PROCEDURE FOR SENDING FAXES"
on page 18.
To cancel a broadcast transmission
Note
To cancel a broadcast transmission when
selecting destinations, press the [CA] key.
To cancel transmission after the
transmission procedure has been
completed, follow the procedure in
"CANCELLING A FAX TRANSMISSION"
(page 25).
] or [ ]
] key to scroll through