Installing The Bezel - Lenovo ThinkServer RD210 Hardware Maintenance Manual

3
5. Remove the screws from the video connector .
6. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on the bottom of the bezel
disengages from the chassis and set it aside.

Installing the bezel

To install the bezel, complete the following steps:
1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
2. Rotate the bezel 2 upward to the server and reinstall the bezel screws 1 .
3. Reinstall the screws on the video connector 3 .
4. Reinstall the hard disk drives and drive bay filler panels into the drive bays.
5. Install the cover (see "Removing and replacing the cover" on page 72).
6. Reconnect the power cords and any cables that you removed.
7. Slide the server into the rack.
8. Turn on the peripheral devices and the server.
128
ThinkServer RD210 Hardware Maintenance Manual