5. If you are instructed to return the power supply, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
6. If you are replacing a defective power supply, continue to "Installing a hot-swap power supply" on
page 99.
Installing a hot-swap power supply
The following notes describe the type of power supply that the server supports and other information that
you must consider when installing a power supply:
To install a hot-swap power supply, complete the following steps:
1. Read the safety information in Chapter 2 "Safety information" on page 3 and "Installation guidelines"
on page 67.
2. Touch the static-protective package that contains the hot-swap power supply
metal surface on the server; then, remove the power supply
static-protective surface.
3. If you are installing a hot-swap power supply into an empty bay, remove the power-supply filler panel
from the power-supply bay.
4. Grasp the handle on the rear of the power supply and slide the power supply forward into the
power-supply bay until it clicks. Make sure that the power supply connects firmly into the power-supply
backplane.
5. Route the power cord through the handle so that it does not accidentally become unplugged.
.
Chapter 7
Installing optional devices and replacing customer replaceable units
2
to any unpainted
2
from the package and place it on a
3
99