Installing The Sas/Sata Raid Riser-Card Assembly - Lenovo ThinkServer RD210 Hardware Maintenance Manual

5. If you are instructed to return the RAID riser-card assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the SAS/SATA RAID riser-card assembly

To install the SAS/SATA RAID riser-card assembly, complete the following steps:
1. Read the safety information in Chapter 2 "Safety information" on page 3 and "Installation guidelines"
on page 67.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables; then,
remove the server cover (see "Removing and replacing the cover" on page 72).
3. Reinstall the SAS/SATA adapter, if one was removed.
4. Reinstall the flash device, if it was removed.
5. Align the SAS/SATA RAID riser-card assembly keys correctly with the connector on the system board and
press down on the assembly until it is seated firmly into the connector on the system board.
6. Connect the signal cables to the SAS/SATA adapter.
7. Install the cover.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
103