Installing The Virtual Media Key - Lenovo ThinkServer RD210 Hardware Maintenance Manual

1
Virtual media key (front)
2
Mounting bracket (rear)
3
Mounting tab
4
Virtual media key connector
5. If you are instructed to return the virtual media key, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the virtual media key

To install the virtual media key, complete the following steps:
1. Read the safety information in Chapter 2 "Safety information" on page 3 and "Installation guidelines"
on page 67.
2. Remove the cover (see "Removing and replacing the cover" on page 72).
3. Align the virtual media key with the mounting tab and slide it down the tab onto the connector on the
system board. Press the virtual media key down into the connector until it is firmly seated on the system
board.
120
ThinkServer RD210 Hardware Maintenance Manual