Removing And Installing A Cd/Dvd Drive; Removing A Cd/Dvd Drive - Lenovo ThinkServer RD210 Hardware Maintenance Manual

11. Reconnect to the system board the cables that you disconnected.
12. Install the cover (see "Removing and replacing the cover" on page 72).
13. Slide the server into the rack.
14. Reconnect the power cords and any cables that you removed.
15. Turn on the peripheral devices and the server.
Important: Perform the following updates:
• Either update the server with the latest RAID firmware or restore the pre-existing firmware from a diskette
or CD image.
• Update the UUID.
• Update the DMI/SMBIOS.

Removing and installing a CD/DVD drive

To remove and install a CD/DVD drive, complete the steps in this section.

Removing a CD/DVD drive

To remove a CD/DVD drive, complete the following steps:
1. Read the safety information in Chapter 2 "Safety information" on page 3 and "Installation guidelines"
on page 67.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing and replacing the cover" on page 72).
4. Press and hold the release tab
5. Slide the drive-retention clip
replacement drive.
114
ThinkServer RD210 Hardware Maintenance Manual
1 down as you push the drive
1 from the side of the drive. Save the clip to use when you install the
2 from the rear to slide it out of the bay.