Lenovo ThinkServer RD210 Hardware Maintenance Manual page 57

Table 3. DSA Preboot messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 9 "Parts listing, ThinkServer RD210 Type 3795, 3796, 3818, and 3819" on page 143 to determine
which components are customer replaceable units (CRU) and which components are field replaceable
units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a Trained service technician.
• Go to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Message
number Component Test
201-808-xxx Memory
201-809-xxx Memory
201-810-xxx Memory
State Description
Memory Aborted Test
Test canceled:
memory
controller
display/alter
buffer
execute
error.
Memory Aborted Test
Test canceled
program
error:
operation
running fast
scrub.
Memory Aborted Test
Test stopped:
unknown
error
code xxx
received in
COMMONEXIT
procedure.
Action
1. Turn off and restart the system.
2. Run the test again.
3. Make sure that the server firmware is at
the latest level. The installed firmware
level is shown in the DSA event log in the
Firmware/VPD section for this component.
4. Run the test again.
5. If the failure remains, go to
http://www.lenovo.com/support for
more troubleshooting information.
1. Turn off and restart the system.
2. Run the test again.
3. Make sure that the DSA code is at the latest
level. For the latest level of DSA code, go to:
http://www.lenovo.com/support
4. Make sure that the server firmware is at
the latest level. The installed firmware
level is shown in the DSA event log in the
Firmware/VPD section for this component.
5. Run the test again.
6. If the failure remains, go to
http://www.lenovo.com/support for
more troubleshooting information.
1. Turn off and restart the system.
2. Run the test again.
3. Make sure that the DSA code is at the latest
level. For the latest level of DSA code, go to:
http://www.lenovo.com/support
4. Make sure that the server firmware is at
the latest level. The installed firmware
level is shown in the DSA event log in the
Firmware/VPD section for this component.
5. Run the test again.
6. If the failure remains, go to
http://www.lenovo.com/support for
more troubleshooting information.
Chapter 5
49
.
Diagnostic