Installing The Battery - Lenovo ThinkServer RD210 Hardware Maintenance Manual

b. Use your thumb and index finger to lift the battery from the socket.
6. Dispose of the battery as required by local ordinances or regulations. See the Safety and Warranty
Guide for more information.

Installing the battery

The following notes describe information that you must consider when replacing the system-board battery in
the server.
• When replacing the system-board battery, you must replace it with a lithium battery of the same type
from the same manufacturer.
• After you replace the system-board battery, you must reconfigure the server and reset the system date
and time.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only an equivalent type battery recommended by the
manufacturer. If your system has a module containing a lithium battery, replace it only with the same
module type made by the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of. Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement system-board battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the replacement battery.
2. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure that the battery clip holds
the battery securely.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
105