Installing The Riser-Card Assembly - Lenovo ThinkServer RS110 Type 6435 Hardware Maintenance Manual

Installing the riser-card assembly

The server comes with one riser-card assembly that contains two PCI Express
connectors.
Riser-card
assembly
To install the riser-card assembly, complete the following steps:
1. Install the adapters in the riser-card assembly.
2. Reconnect any adapter cables that you disconnected when you removed the
3. Carefully align the riser-card assembly with the guides on the rear of the server
4. If the riser-card assembly is an optional PCI-X riser-card assembly, reconnect
5. Install the cover (see "Installing the cover" on page 61).
Note: If you have installed a Remote Supervisor Adapter II SlimLine in the
server, you can install only a half-length adapter in expansion slot 1.
riser-card assembly.
and with the riser-card connectors on the system board; then, press down on
the assembly. Make sure that the riser-card assembly is fully seated in the
riser-card connectors on the system board.
the riser-card power cable to the riser-card assembly.
Chapter 4. Removing and replacing server components
89