Built-In Refrigeration
Ice and Water Dispenser
MODELS BI-42SD AND BI-48SD
For models BI-42SD or BI-48SD, the refrigerator door
panel must include a cut-out to accommodate the dis-
penser glasswell and bezel. The thickness of the panel in
this area can range from
IMPORTANT NOTE: Regardless of the thickness of the
panel for model BI-42SD or BI-48SD, you must plan for a
flat landing area for the decorative bezel surrounding the
glasswell area. The illustration to the right provides exact
bezel dimensions. Refer to the appropriate panel specifi-
cations page for exact cut-out location. This landing area
can be accomplished in a number of different ways. These
photos show two options.
One option (flush) is to rout the panel so the bezel will be
flush with rails and stiles. You must rout a space to
accommodate the height and width of the bezel. The
width of the stile immediately to the left of the bezel must
3
be 1
/
"
. Do not cut the entire stile to this dimension.
(44)
4
The other option (proud) shows a boxed out landing area
for the bezel using stiles and rails to create this space. In
this application, the bezel will sit proud of the stiles and
rails. The total thickness of the panels at this level must
1
not exceed 1
/
"
.
(29)
8
Flush option.
1
/
"
to a maximum of 1
(6)
4
Proud option.
For overlay and flush inset models, mounting placement of
the refrigerator door handle must assure proper access to
the glasswell and adequate clearance under the handle.
The handle placement illustration shows the relation of the
refrigerator door handle to the glasswell bezel on stainless
1
/
"
.
(29)
8
steel models.
5
/
"
8
(16)
7
12
/
"
8
(327)
Dispenser dimensions.
3
/
"
32
(2)
5
6
/
"
16
(160)
1"
(25)
1
/
"
8
(3)
RADIUS
Handle placement.
28
GLASSWELL
HANDLE
2"
(51)