Table of Contents
Advertisement
Paper Sources
You can select from the paper sources listed below.
Cassette 1 is the default source when it is the only
cassette. Autoswitching is the default when an optional
cassette/feeder is installed. Optional feeders (Cassette
2, Cassette 3, and the Envelope Feeder) are not available
for selection if they are not installed on your printer.
Autoswitching:
The printer automatically detects
and uses the paper cassette that has the appropriate
size paper for the print job. Then, if the first cassette
runs out of paper, the printer uses the next cassette
that has the same size paper if one is available. (The
printer will not switch to the multipurpose feeder as
a paper source.)
All standard-size media can be
Multipurpose Feeder:
automatically or manually fed from this feeder.
However, the multipurpose feeder cannot be the
paper source when using the duplex unit to print
double-sided.
This is the standard 250-sheet feeder
Cassette 1:
with cassette. It is adjustable for A4, Letter, Legal,
Executive, and B5 (JIS) sizes.
This optional 500-sheet feeder/cassette
Cassette 2:
is adjustable for A4, Letter, and Legal sizes.
This optional 500-sheet feeder/cassette
Cassette 3:
is adjustable for A4, Letter, and Legal sizes.
This optional feeder holds up to
Envelope Feeder:
75 envelopes. It is adjustable for Monarch, Com 10,
DL, and C5 sizes.
Caution!
Do not remove Cassette 1 when paper is
feeding from Cassettes 2 or 3—this will cause a paper
jam.
Orientation
Orientation describes the position of images on a page
with respect to the long and short edges of the paper.
The default setting is Portrait.
Portrait:
The page is taller than wide as you view
the text upright.
The page is wider than tall as you view
Landscape:
the text upright.
Orientation Options
Landscape
Portrait
Paper Destination
Each paper destination has a full stack sensor and the
printer will send a message when the tray is full. You
can select from the following options.
Print job is delivered face down to the
Output Tray:
standard output tray, which holds up to 250 sheets
of paper. This is the default setting.
Offset Tray:
Print job is delivered face down to the
optional offset tray, which holds up to 500 sheets of
paper. In addition, when you select the offset tray,
the job separation feature is automatically activated.
Job Separation
Job Separation is activated when the offset tray is
installed and selected for output. When Job Separation
is active, print jobs are shifted (offset) by 2.8 cm for
easier sorting.
Standard Printer Settings
1–7
Advertisement
Table of Contents
