Entering The Bios Setup - Fujitsu BX630 - PRIMERGY - S2 Dual Operating Manual

BIOS Setup
6.1

Entering the BIOS Setup

Ê Start the server blade (cold or warm start).
The subsequent procedure depends on the current setting of the Boot Menu
parameter in the Boot menu (see also
Boot Menu = Disabled
With this parameter setting, you can open the Main menu.
Boot Menu = Enabled
With this parameter setting, you can open the Main menu or a pop-up
boot menu.
Opening the Main menu
Ê Press the [F2] function key.
Ê Enter the Setup password (if defined) and confirm your entry by pressing
Enter.
Opening the pop-up boot menu
Use this function if you do not want to start your system from the drive that is set
as the first option in the Boot Sequence parameter in the Boot menu.
Ê Press [ESC].
A pop-up boot menu is displayed.
Ê Use the Ê or Ë cursor keys to select the drive from which you want to start
the operating system, and confirm your selection by pressing Enter. The
selection options are the same as the possible settings of the Boot priority
order parameter in the Boot menu.
If a drive is marked with an exclamation mark (!), you cannot select it for
booting.
I
The option you select only applies to the current system start. The
next time you start the system, the settings of the Boot Sequence
parameter in the Boot menu will apply again.
Ê To start the BIOS Setup, select the Setup parameter and confirm your
selection with Enter. The Main menu opens and, if applicable, you must
enter and confirm the Setup password.
BX630 S2
section "Boot menu" on page
Operating Manual
Entering the BIOS Setup
71):
43