Fujitsu BX630 - PRIMERGY - S2 Dual Operating Manual page 9

Preface
Graphics controller
The PRIMERGY BX630 S2 scalable server blade has an onboard graphics
controller (Matrox MGA-200) which is integrated in the iRMC controller. You can
connect a monitor via the VGA interface (via breakout cable) on the front of the
server blade or via the KVM blade on the back of the basic unit.
Optional Fibre Channel or Ethernet I/O module (daughter card)
You can fit the BX630 S2 dual-socket server blade with an I/O daughter card to
connect to a SAN or for additional Ethernet connections. The BX630 S2 quad-
socket server blade allows two I/O daughter cards to be installed.
To be able to use the additional I/O functionality, at least one FC pass-thru blade
or switch blade, or Ethernet pass-thru blade or switch blade must be installed in
slot NET3 of the basic unit.
The following I/O daughter cards are available:
– 4-Gbit/s Fibre Channel I/O module (PCIe), allows transfer rates of 1, 2 or 4
Gbit/s and supports multiple Fibre Channel storage subsystems with the
corresponding versions.
I
You can operate the 4-Gbit/s Fibre Channel I/O module only with a
BX600 S3 basic unit and only in combination with a Brocade SW-
4016 D4 Fibre Channel switch blade or with a 4 Gbit FC pass-thru
blade. For more information see the operating manual for the
BX600 S3 basic unit.
– Gigabit Ethernet I/O module (PCIe), also supports TOE (TCP/IP offload
engine) and iSCSI
– 10-Gbit Ethernet I/O module (PCIe)
I
The 10-Gbit Ethernet I/O module (PCIe) can only be used in combi-
nation with a 10-Gbit switch blade 10/2. For more information see the
operating manual for the basic unit.
I
You must not install server blades with different I/O modules in the same
BX600 S2 or BX600 S3 basic unit.
How to install I/O modules later is described in the Options Guide.
BX630 S2
Operating Manual
Features
9