Fujitsu BX630 - PRIMERGY - S2 Dual Operating Manual page 37

Installation and Operation
Ê Connect the monitor, keyboard and mouse to the KVM blade on the rear of
the basic unit. For information see the BX600 S2 or BX600 S3 basic unit
operating manual.
Ê Press the KVM button (position 4 in
of the server blade to switch the keyboard, mouse and the monitor of the
KVM blade to the server blade.
Preparing the Software
Booting from the CD-ROM drive
Boot the relevant server blade from the ServerView Installation Manager CD to
install the operating system. In some cases this may require that you change a
few settings:
Ê Insert the ServerView Installation Manager CD in the CD-ROM drive and press
the On/Off button (position 2 in
the server blade.
Ê Press the KVM button (position 4 in
of the server blade to switch the keyboard, mouse and the monitor of the
KVM blade to the server blade. Wait a few seconds for the monitor to be
activated.
Ê When prompted, press [F2] to call up the BIOS setup of the server blade.
Ê In the BIOS setup menu select the Boot submenu and enable Boot from CD-
ROM Drive.
Ê Press [ESC] twice and select Exit Saving Changes from the Exit menu.
Once the server blade has booted from the ServerView Installation Manager CD,
the startup screen is displayed.
BX630 S2
figure 7 on page
figure 7 on page
figure 7 on page
Operating Manual
Configuring the Server Blade
32) on the control panel
32) on the control panel of
32) on the control panel
37