Fujitsu BX630 - PRIMERGY - S2 Dual Operating Manual page 25

Installing the Hardware
Figure 3: Removing the dummy module for a server blade
Ê Undo the locking mechanism of the handles by pressing the green inside
touch points of the two handles (1). This undoes the locking handles of the
dummy module.
Ê Swivel the top handle upward and the bottom handle downward (2) simulta-
neously until the locking mechanism of the dummy module disengages and
releases the module.
Ê Pull the dummy module completely out of the slot (3).
V
CAUTION!
Keep the dummy module for future use. If a server blade is removed
again and not replaced with a new one, the dummy module must be
reinstalled because of cooling, fire protection and EMC regulations.
Install the dummy module in the same way as the server blade as described in
the section below.
BX630 S2
Installing the Server Blade in the Basic Unit
Operating Manual 25