General Programming; Master Code; Single Or Multiple Systems; Relay Strike Time - DKS 1803 Owner's Manual

3.1 GENERAL PROGRAMMING

3.1.1 Master Code

This programming step sets the system MASTER CODE. The master code is the four-digit number
required to gain access to the system memory.
performing any of the programming functions on the following pages.
NOTE: The master code cannot be programmed from an off-site location. The master code
can only be programmed from the system keypad.
Factory setting = 9999
1. Open the cabinet of the telephone entry system and turn the master code switch (the
small toggle switch) on.
2. Enter a four-digit master code
3. Turn the master code switch off and close the cabinet.

3.1.2 Single or Multiple Systems

This program sequence sets the telephone entry system to operate as a single unit on the phone line,
or to share the phone line with other units. If multiple systems are sharing the same phone line, then
each one must be set as a "multiple system" and each must have a unique master code.
Factory setting = Single System.

1. Press and then enter the four-digit MASTER CODE

2. Enter (beep) for a single system or

3. Press TOGETHER to end this programming step (beeeeeep).

3.1.3 Relay Strike Time

These steps will program Relay 1 and Relay 2 strike times. Strike times can be programmed from 1/4
second (enter 00 in step 3) up to 99 seconds by entering the desired time in seconds.
Factory setting for relay strike times are: Relay 1 = 01, Relay 2 = 01.

1. Press

2. Press to set relay 1, or
3. Enter the two-digit strike time
4. Repeat steps 2 and 3 to set the other relay strike time.

5. Press TOGETHER to end this programming step (beeeeeep).
BBBB
then press

and enter the four-digit MASTER CODE

to set relay 2 strike time.
BB
(00-99) then press
You need to know the master code prior to
(beep).
BBBB
(beep) for multiple systems.
BBBB
(beep).
28
(beep).
(beep).