Installing The Driver For Windows 2000 - Cisco AIR-PCM342 Hardware Installation Manual

Installing the Correct Driver
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Step 16

Installing the Driver for Windows 2000

Step 1
Step 2
Step 3
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
3-14
In the Adapter Setup window, select Client Name. Type your computer's unique
client name in the Value dialog box.
Select SSID. Type your RF network's (case-sensitive) SSID in the Value dialog
box.
Enter an available IRQ number, which you obtained in Step 2.
Click OK and Close.
The Microsoft TCP/IP Properties window should open. If it does not open,
double-click My Computer, Control Panel, and Network. Select Protocols,
TCP/IP, and Properties.
Perform one of the following:
If you are connected to a DHCP server, select Obtain an IP address from a
•
DHCP server. When asked if you want to enable DHCP, click Yes and OK.
• If you are not connected to a DHCP server, select Specify an IP address and
enter the IP address, subnet mask, and default gateway address of your
computer (which can be obtained from your system administrator). Click
OK.
When prompted to restart your computer, remove the CD and click Yes.
The driver installation is complete.
If your computer's operating system is Windows 2000, follow these steps.
After you insert the client adapter into your computing device, Windows 2000
automatically detects it and briefly opens the Found New Hardware window.
The Found New Hardware Wizard window opens and indicates that the wizard
will help you to install the driver.
Click Next. Another window opens and asks what you want the wizard to do.
Select Search for a suitable driver for my device (recommended) and click
Next.
Chapter 3 Installing the Client Adapter
OL-0795-01