Verifying Installation - Cisco AIR-PCM342 Hardware Installation Manual

Chapter 3 Installing the Client Adapter
Note

Verifying Installation

OL-0795-01
After LEAP or EAP is enabled on your client adapter, you can
enable or disable it at any time using ACU. Refer to the Cisco
Aironet Wireless LAN Adapters Software Configuration Guide for
more information.
To verify that you have properly installed the appropriate driver and client
utilities, perform one of the following:
If your computer's operating system is Windows 95, 98, NT, 2000, or Me,
•
open ACU by double-clicking the ACU icon on your desktop. If the
installation was successful, the bottom left corner of the Aironet Client
Utility screen indicates that your client adapter is associated to its Access
Point.
If your computer's operating system is Windows CE 2.11 or 3.0, open ACU
•
by selecting Start > Programs > Cisco > Aironet Client Utility. If the
installation was successful, the bottom of the ACU screen indicates that your
client adapter is associated to its Access Point.
If your computer's operating system is Linux, go to the directory where the
•
utilities were installed and type acu to open ACU. If the installation was
successful, the bottom left corner of the Aironet Client Utility screen
indicates that your client adapter is associated to its Access Point.
If your computer's operating system is MacOS 9.x, double-click the
•
pcm3x0PPC icon in the Cisco pcm3x0 folder to open the pcm3x0PPC client
utility. If the installation was successful, the top of the Basic Properties
screen indicates that your client adapter is associated to its Access Point.
To verify that your client adapter is authenticated and has received a
session-based WEP key (if you are running Windows 95, 98, NT, 2000, or Me and
you enabled LEAP or EAP on your client adapter), check the system tray on your
desktop. The WepStat icon, which looks like two connected computers, should
appear in the system tray and indicate that LEAP or EAP is authenticated and
WEP is enabled. In addition, LEAP or EAP and Enable WEP should be selected
in the Network Security screen in ACU.
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
Verifying Installation
3-33