Cisco AIR-PCM342 Hardware Installation Manual page 58

Installing the Correct Driver
Drag and drop the client utility files, which have an .exe extension, from the CD
Step 7
to the \Windows\Programs\Cisco directory of the Windows CE device. The client
utility files are located in a directory specific to the Windows CE version and
processor type.
Example: The client utility files for Windows CE 2.11 on a MIPS processor
After the files are copied, remove the CD.
Step 8
Step 9 Disconnect the Windows CE device and reboot it.
Follow the instructions in the "Inserting the Client Adapter into a Computing
Step 10
Device" section on page 3-2 to insert the client adapter into the PC card slot of
the Windows CE device.
The Unidentified PCCard Adapter dialog box appears with the driver name set to
Network card in Socket X. If the driver name is set to anything other than a
network card, remove the client adapter, reset the Windows CE device, and
reinsert the client adapter.
Step 11 Type aironet for the driver name and click OK.
The Windows CE device should configure the client adapter, and the green LED
on the adapter should blink. If this does not happen, remove the client adapter,
reset the Windows CE device, and go back to Step 10.
The Aironet Wireless LAN Adapter Settings dialog box appears. Perform one of
Step 12
the following:
•
•
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
3-20
would be located in the following directory structure:
WinCE\Ce2.11\Mips.
If you are connected to a DHCP server, select Obtain an IP address via
DHCP or Use server-assigned IP address and click OK.
If you are not connected to a DHCP server, select Specify an IP address or
Use specific IP address and follow the steps below:
Enter the IP address, subnet mask, and default gateway address of your
a.
computer (which can be obtained from your system administrator).
Select the Name Servers tab and enter the primary and secondary DNS
b.
and WINS for your computer (which can be obtained from your system
administrator).
Click OK.
c.
Chapter 3 Installing the Client Adapter
OL-0795-01