Removing The Driver - Cisco AIR-PCM342 Hardware Installation Manual

Chapter 4 Troubleshooting and Routine Procedures

Removing the Driver

OL-0795-01
This section provides instructions for removing a client adapter driver from your
computer. Two examples of when you may need to remove a driver are listed
below:
If you are running Windows 95, 98, NT, or 2000 and a Cisco Aironet client
•
adapter was previously installed on your computer with the 6.10 driver, you
must remove this driver before you can install a more recent driver, such as
the one provided on the Cisco Aironet Series Wireless LAN Adapters CD.
If you experience difficulty while installing the driver for your computer's
•
operating system, you may want to abort the installation procedure and start
over. However, before you attempt to install the driver again, you must first
remove any part of the driver that you may have already installed.
Table 4-2 enables you to quickly locate the instructions for removing a driver for
your specific operating system.
Table 4-2 Locating Driver Removal Instructions
Operating System
Windows 95
Windows 98
Windows NT
Windows 2000
Windows Millennium (Me)
Windows CE 2.11
Windows CE 3.0
Linux
MacOS 9.x
Cisco Aironet Wireless LAN Adapters Hardware Installation Guide
6.10 Driver
page 4-10
page 4-10
page 4-11
page 4-12
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable

Removing the Driver

Driver Other Than 6.10
page 4-13
page 4-13
page 4-14
page 4-15
page 4-13
page 4-16
page 4-16
page 4-17
page 4-17
4-9