Compaq ProLiant 2500 Maintenance And Service Manual page 93

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
Controller firmware needs upgrading (DAAD Error 102)
You have the correct controller; however, the array controller firmware version should be
greater than 1.26.
Call your Authorized Compaq Reseller to obtain the latest firmware.
Controller is not configured
The controller is not configured. If the controller was previously configured and you
change drive locations, there may be a problem with the placement of the drives. DAAD
examines each physical drive and looks for drives that have been moved to a different drive
bay.
Look for the messages that indicate which drives have been moved. If none appear and
drive swapping did not occur, run the System Configuration Utility to configure the
controller and nonvolatile RAM. Do not run the System Configuration Utility if you believe
drive swapping has occurred.
Controller needs replacing (DAAD Error 102)
The array controller firmware is less than version 0.96.
Replace the controller as soon as possible.
Controller needs replacing (DAAD Error 104)
The Intelligent Array Expansion System firmware is less than version 1.14.
Replace the controller as soon as possible.
Controller reported POST error. Error Code: x
The controller returned an error from its internal Power-On Self-Tests.
Replace the controller.
Controller restarted with a signature of zero
DAAD did not find a valid configuration signature to use to get the data. Nonvolatile RAM
may not be present (unconfigured) or the signature present in nonvolatile RAM may not
match the signature on the controller.
Run the System Configuration Utility to configure the controller and nonvolatile RAM.
Compaq ProLiant 2500 Family of Servers Maintenance and Service Guide
3-41