Compaq ProLiant 2500 Maintenance And Service Manual page 67

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
POST Error Messages
1786-Drive Array
Recovery Needed
The following
drive(s) need
Automatic Data
Recovery: Drive X .
Select "F1" to
continue with
recovery of data
to drive(s). Select
"F2" to continue
without recovery of
data to drive(s).
1787-Drive Array
Operating in
Interim Recovery
Mode.
Physical drive
replacement
needed: Drive X
*1788-Incorrect
Drive Replaced:
Drive X Drive(s)
were incorrectly
replaced: Drive Y
Select "F1" to
continue - drive
array will remain
disabled. Select
"F2" to reset
configuration - all
data will be lost.
Continued
Error Code Beeps
None
None
None
Compaq ProLiant 2500 Family of Servers Maintenance and Service Guide
Probable Source of
Problem
Interim Data Recovery
mode. Data has not
been recovered yet.
Hard drive X failed or
cable is loose or
defective. Following a
system restart, this
message reminds you
that drive X is defective
and fault tolerance is
being used.
Drives are not installed
in their original
positions, so the drives
have been disabled.
See note below.
Action
Press F1 key to allow
Automatic Data
Recovery to begin.
Data will automatically
be restored to drive X
now that the drive has
been replaced or now
seems to be working.
-Or-
Press the F2 key and
the system will
continue to operate in
the Interim Data
Recovery mode.
1. Replace drive X as
soon as possible.
2. Check loose
cables.
3. Replace defective
cables.
Reinstall the drives
correctly as indicated.
Press F1 to restart the
computer with the
drive array disabled.
-Or-
Press F2 to use the
drives as configured
and lose all the data
on them.
3-15