Mass Storage For Duplexed Hot-Pluggable Models; Mass Storage For Non-Hot-Pluggable Models - Compaq ProLiant 2500 Maintenance And Service Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
Switch and Jumper Information
4-6
Mass Storage for Duplexed Hot-Pluggable
Models
Table 4-4 shows the jumper settings for each SCSI ID and its recommended drive bay.
Figure 4-3 shows the physical locations of jumpers ID2, ID1, and ID0 on supported
options.
Device in Drive Bay
NOTE: SCSI IDs for bays 0-3 are preset to 0-3 respectively. No two devices can have
the same SCSI ID.

Mass Storage for Non-Hot-Pluggable Models

The Integrated Wide-Ultra SCSI Controller requires that a SCSI ID be set for each SCSI
device. The SCSI ID is set by jumpers ID2, ID1, and ID0 located on each SCSI device.
Table 4-5 shows the jumper settings for each SCSI ID and its recommended drive bay.
Figure 4-3 shows the physical locations of jumpers ID2, ID1, and ID0 on supported
options.
Device in Drive Bay
NOTE: No two devices can have the same SCSI ID.
Jumper Settings for SCSI ID
SCSI ID
5 5
4 4
Jumper Settings for SCSI ID
SCSI ID
5 5
4 4
3 3
2 2
1 1
0 0
Table 4-4
Bit 2 Bit 1
ID2
ON OFF
ON OFF
Table 4-5
Bit 2 Bit 1
ID2
ON OFF
ON OFF
OFF
OFF
OFF OFF
OFF OFF
Bit 0
ID1 ID0
ON
OFF
Bit 0
ID1 ID0
ON
OFF
ON ON
ON OFF
ON
OFF