Specify The Profile Set Name; Launch Color Centro Profiler - Konica Minolta bizhub PRESS C6000 User Manual

13.5 Create the Profile Set
13.5.1

Launch Color Centro Profiler

You can create the Profile Set by using Color Centro Profiler.
1
Click [Profile Set] - [New] on [Color Configuration Management] screen.
Color Centro Profiler is launched as wizard and then [Confirmation of procedure] screen appears.
2
Confirm the contents, and click [Next].
[Name Settings] screen appears.
% Go to the step described on page 13-16.
13.5.2

Specify the Profile Set Name

1
Specify the name of Profile Set you create to [Profile Set Name] of [Name Settings] screen.
% You cannot save the Profile Set of the same name with those registered at factory shipping in the
image controller.
% You cannot use "DEVICE" (not only the capital letter but also the small letter) for the Profile Set name
when you save the profile to the image controller.
2
Click [Next].
The Profile Determination screen appears
% When there is a Profile Set with the same name, the [Confirmation : Overwrite] screen appears. To
save with another name, click [Cancel]. To overwrite, click [OK].
% Go to the step described on page 13-17.
IC-601
13
13-16