12.5
Return to Factory Default
12.5
Return to Factory Default
This section describes how to return the Color Default Settings of the image controller to the factory default.
The factory default settings are as follows;
[RGB] tab
[No Color Conversion]
[Use RGB-CMYK Device Link Profile]
[Use RGB Source Profile]
[Rendering]
RGB Simulation
[CMYK] tab
[No Color Conversion]
[Use CMYK-CMYK Device Link Profile]
[Use CMYK Target Profile]
[Paper Simulation]
[Other Settings] tab
[Printer Profile]
[Paper Type Link]
[Tone Curve]
[Pure Black]
[Gray Replacement]
[Black Overprint]
[Composite Overprint]
[Use Spot Color]
[Use Alternative Color Conversion]
1
From the [File] menu, select [Return to Factory Default].
The confirmation message appears.
2
Click [OK].
Resets the priority to the factory default.
% When you want to register the initialized settings of Color Default, go to the step described on
page 12-11.
IC-601
Check Job
OFF
OFF
ON
C8000/C7000/C6000: Saturation
C70hc: Perceptual
OFF
Check Job
OFF
OFF
ON
OFF
Check Job
For Coat Paper
OFF
Default Tone Curve
Text/Graphic
OFF
OFF
OFF
OFF
OFF
12
12-10