Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 64

JUNOSe 10.0.x Physical Layer Configuration Guide
show controllers t3 ft1
show controllers t3 remote
38
Monitoring Interfaces
Degraded minutes = 0
Line code violations = 0
See show controllers t1.
See show controllers t3.
Use to display information about the state of a fractional T1 subchannel.
Field descriptions
Description Text description or alias if configured for the interface
ifOperStatus Physical status of the interface
ifOperUp Interface is functioning
ifOperTesting Interface is being tested
ifOperNotPresent Module has been removed from the chassis
ifOperDown Interface is not functioning
snmp trap link-status of SNMP trapping (enabled or disabled)
Ds0 time slot map Fractional T1 subchannel
Ds0 mode Base data rate: either Nx56 or Nx64
The ft1 option displays the state of the serial interface.
The optional slot and port parameters display information about a specific slot
and port.
Example
host1#show controllers t3 ft1
Ft1 Interface at 2/0:1/1
Description: toronto ft1 interface
ifOperStatus = ifOperLowerLayerDown
snmp trap link-status = disabled
Ds0 time slot map = 0x1
Ds0 mode = Nx64
See show controllers t3.
Use to display MIB statistics for the remote end of a channelized T3 interface
configured for MDL or for the remote end of a T1 channel configured for FDL.
Specify the all option to display detailed information for all 15-minute intervals.
For definitions of the MIB statistics for a T3 interface, see RFC 2496 Definitions
of Managed Objects for the DS3/E3 Interface Types (January 1999).
For definitions of the MIB statistics for a T1 channel, see RFC 2495 Definitions
of Managed Objects for the DS1, E1, DS2 and E2 Interface Types (January 1999).