Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 188

JUNOSe 10.0.x Physical Layer Configuration Guide
162
Monitoring Interfaces
Description Text description or alias if configured for the interface
BERT test Number of current test and total number of tests
Test interval Length of the BERT test
status Sync (controller is synchronized with remote device) or NoSync
(controller is not synchronized with remote device
Sync count Number of times the pattern detector synchronized with
the incoming data pattern
Received bit count Number of bits received
Error bit count Number of bits with errors
Number of valid intervals Number of 15-minute intervals since the line
module was last powered on or reset
Time elapse in current interval Time (seconds) passed in current interval
Current Interval Counters Statistics for the current 15-minute interval
P-bit errored seconds Number of errored seconds encountered by a T3
P-bit severely errored seconds Number of severely errored seconds
encountered by a T3
Severely errored frame seconds Number of severely errored framing
seconds encountered by a T3
Unavailable seconds Number of unavailable seconds encountered by a T3
Line code violations Number of line code violations encountered by a T3
P-bit coding violations Number of coding violations encountered by a T3
Line errored seconds Number of line errored seconds encountered by a
T3
C-bit coding violations Number of C-bit coding violations encountered by
a T3
C-bit errored seconds Number of C-bit errored seconds encountered by a
T3
C-bit severely errored seconds Number of C-bit severely errored seconds
encountered by a T3
24 Hour Total counters Statistics for last 24 hours
Example 1 This example shows all T3 controllers on the interface 2/1.
host1#show controllers sonet 2/1 ds3
Ds3 1
Description: ottawa211 ds3
Number of valid interval - 0
Time elapse in current interval - 696