Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 158

JUNOSe 10.0.x Physical Layer Configuration Guide
path ds3 description
path ds3 framing
path ds3 shutdown
path ds3 snmp trap link-status
132
Configuration Tasks
Use the no version to restore the default value, line.
See path ds3 clock source.
Use to assign a text description or an alias to a T3 (DS3) over channelized
SONET/SDH interface.
You can use this command to help you identify the interface and keep track of
interface connections.
The description or alias can be a maximum of 80 characters.
Use "show controllers sonet ds3" on page 161 to display the text description.
Example
host1(config-controller)#path 12 ds3 1 description boston_t3
Use the no version to remove the text description or alias.
See path ds3 description.
Use to configure the framing format for a T3 interface.
Specify c-bit parity framing or m23 multiplexer framing.
Example
host1(config-controll)#path 12 ds3 1 framing m23
Use the no version to restore the default value, c-bit parity framing.
See path ds3 framing.
Use to disable a T3 interface.
T3 interfaces are enabled by default.
Example
host1(config-controll)#path 12 ds3 1 shutdown
Use the no version to restart a disabled interface.
See path ds3 shutdown.
Use to enable SNMP link status processing for a T3 interface.
The default disables SNMP link status processing.
Example
host1(config-controll)#path 12 ds3 1 snmp trap link-status