Table of Contents
Advertisement
show controllers sonet line | path | section
Operational Status Physical state of the controller: up, down, or
lowerLayerDown
time since last status change: time the controller has been in the current
physical state
Received SONET Path overhead Path overhead bytes present in the receive
side of the interface at any particular time
Transmitted SONET Path overhead Path overhead bytes present in the
transmit side of the interface at any particular time
Example
host1# show controllers sonet 1/0
show controllers sonet 1/0oc3 1/0
non channelized
ifAdminStatus: up
description: link1
snmp trap link-status: enabled
alarms used for operational status calculation: LOS LOF AIS RDI
defect trigger soaking delay: 2500 milliseconds
Operational Status: down, failure alarm: AIS
time since last status change: 07:33:12
Loopback State: none
Mode: sonet
Timing source: line
Receive FIFO Overruns: 0, Framer stats: 0/0
Current section defects: none
Current line
defects: AIS
Received SONET overhead:
F1
:
n/a, J0
: 0xFF
Transmitted SONET overhead:
F1
: 0x00, J0
: 0x00
Channel configuration:
channel = 0, path = oc3, hierarchy = 1/0, current path defects:
LowerLayerDefect
ifAdminStatus: up
snmp trap link-status: disabled
alarms used for operational status calculation: LOP AIS
defect trigger soaking delay: 2500 milliseconds
c2 byte set by upper interface type
Operational Status: lowerLayerDown
time since last status change: 07:33:12
Received SONET Path overhead:
F2
:
n/a, Z3
: 0x00
Transmitted SONET Path overhead:
F2
: 0x00, Z3
See show controllers sonet.
Chapter 3: Configuring Unchannelized OCx/STMx Interfaces
:
n/a, K1
: 0xFF, K2
: 0x01, K1
: 0x00, K2
:
n/a, Z4
:
n/a, C2
: 0x00, Z4
: 0x00, C2
Monitoring SONET/SDH Interfaces
: 0xFF, S1
: 0x00, S1
: 0xFF, C2Exp
: 0x00
101
Advertisement
Table of Contents
