Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 231

For e series routing platforms - physical layer configuration
Table of Contents

Advertisement

show interfaces gigabitEthernet
show interfaces tenGigabitEthernet
Duplex Mode: Operational Full Duplex, Administrative Auto Negotiate
Speed: Operational 100 Mbps, Administrative Auto Negotiate
De-bounce: State is Enabled, interval is 2 seconds
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
In: Bytes 39256, Unicast 612
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Alignment 0
CRC 0, Too Longs 0, Symbol Errors 0
Out: Bytes 4579036, Unicast 610
Multicast 0, Broadcast 70932
Errors 0, Discards 0, Mac Errors 0, Deferred 0, No Carrier 3
Collisions: Single 0, Multiple 0, Late 0, Excessive 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Administrative qos-shaping-mode: none
Operational qos-shaping-mode: none
queue 0: traffic class control, bound to FastEthernet2/0
Queue length 0 bytes
Forwarded packets 1, bytes 46
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
See show interfaces.
Use to display the status of Gigabit Ethernet interfaces and 10-Gigabit Ethernet
interfaces.
You can specify the following keywords:
delta Specifies that baselined statistics are to be shown
brief Displays the operational status of all configured interfaces
Field descriptions
GigabitEthernet or tenGigabitEthernet interfaceSpecifier Status of the
hardware on this interface
up Hardware is operational
down Hardware is not operational
Administrative status Operational state that you configured for this interface
up Interface is enabled
down Interface is disabled
Hardware Type of MAC device on this interface
Chapter 5: Configuring Ethernet Interfaces
Monitoring Ethernet Interfaces
205

Advertisement

Table of Contents
loading

Table of Contents