Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 232

JUNOSe 10.0.x Physical Layer Configuration Guide
206
Monitoring Ethernet Interfaces
Address MAC address of the processor on this interface
MAU Type of medium attachment unit (MAU) on the primary and secondary
physical ports:
SFP 1000BASE-LH, 1000BASE-SX, 1000BASE-ZX; for SFPs that are
empty, SFP (Empty) appears in this field; for SFPs that are installed in
the OC3-2 GE APS I/O module and do not have a Juniper Networks part
number programmed, SFP (GE Compliant) appears in this field
XFP 10GBASE-SR (10 Gbps), 10GBASE-LR (10 Gbps), 10GBASE-ER
(10 Gbps); for XFPs that are empty, XFP (Empty) appears in this field
MTU Size of the MTU for this interface
Operational Size of the largest packet processed
Administrative Setting for MTU size that you specified
Duplex Mode Duplex option for this interface
Operational Duplex option currently used
Administrative Setting for duplex that you specified
Speed Line speed for this interface
Operational Current rate at which packets are processed
Administrative Setting for line speed that you specified
De-bounce Debounce configuration for this interface
State is Enabled, Disabled
Interval is Number of seconds that this interface maintains a given
state before the state change is reported to the upper-layer links
Link Link information for this interface
Operational Link Selected Port that the I/O module is currently using:
primary or secondary
Administrative link selected Port that the I/O module is configured to
use:
primary Only primary port is configured to operate
secondary Only redundant port is configured to operate
automatically Software controls port redundancy automatically
Primary link selected x times Number of times that the I/O has used the
primary port since the module was last rebooted
Secondary link selected x times Number of times that the I/O has used the
secondary port since the module was last rebooted