Table of Contents
Advertisement
ds3-scramble
e3-scramble
framing
Use to assign a text description or an alias to a T3 or E3 interface.
You can use this command to help you identify the interface and keep track of
interface connections.
The description or alias can be a maximum of 80 characters.
Use "show controllers t3" on page 65 or "show controllers e3" on page 65 to
display the text description.
Example
host1(config-controll)#description westford t3 interface
Use the no version to remove the text description or alias.
See description.
Use to enable cell scrambling in a T3 ATM interface.
Example
host1(config-controll)#ds3-scramble
Use the no version to turn off cell scrambling on the interface.
See ds3-scramble.
Use to enable cell scrambling in an E3 ATM interface.
Example
host1(config-controll)#e3-scramble
Use the no version to turn off cell scrambling on the interface.
See e3-scramble.
Use to configure the framing format for a T3 or E3 line.
For a T3 line, you must specify one of the following:
T3 FRAME c-bit or m23 (the default is c-bit)
T3 ATM cbitadm, cbitplcp, m23adm, or M23plcp (the default is cbitplcp)
For an E3 line, you must specify one of the following:
E3 FRAME g751 or g832 (the default is g751)
Choose a framing format that is compatible with the framing format of the
network device at the other end of the line.
Example
host1(config-controll)#framing m23
Chapter 2: Configuring T3 and E3 Interfaces
Configuration Tasks
55
Advertisement
Table of Contents
