Table of Contents
Advertisement
path ds1 fdl carrier
path ds1 fdl string
NOTE: The router sends these FDL messages only if you have issued the path ds1
fdl command with the ansi or all keyword and then issued the path ds1 fdl transmit
command.
path ds1 fdl transmit
NOTE: The router sends FDL messages specified with the path ds1 fdl string command
only if you have issued the path ds1 fdl command with the ansi or all keyword. If
you specified the att keyword with the path ds1 fdl command, the router sends only
performance data.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl att
Use the no version to restore the default, none.
See path ds1 fdl.
Use to specify that an interface is used in the carrier environment.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl carrier
Use the no version to restore the default situation, in which the T1 interface does
not operate in the carrier environment.
See path ds1 fdl carrier.
Use to configure an FDL message as defined in the ANSI T1.403 specification.
Example
host1(config-controll)#path 2 ds1 1/1/1 fdl string eic "ERX-1440"
Use the no version to restore the default value to the specified FDL message or
to all FDL messages.
See path ds1 fdl string.
Use to configure the router to send the specified type of FDL message on the T1
channel.
By default, the router sends no FDL messages.
Specify the keyword path-id to transmit path identifications every second.
Specify the keyword idle-signal to send idle signals every second.
Chapter 4: Configuring Channelized OCx/STMx Interfaces
Configuration Tasks
129
Advertisement
Table of Contents
