Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 185

show controllers sonet ds1|e1
host1#show controllers sonet 2/1:1/1
oc3 2/1
channelized (3 channels, oc1 minimum speed)
ifAdminStatus: up
description: link1
snmp trap link-status: enabled
alarms used for operational status calculation: LOS LOF AIS RDI
defect trigger soaking delay: 2500 milliseconds
Operational Status: up
time since last status change: 00:03:30
Loopback State: none
Mode: sonet
Timing source: internal module
Current section alarms: none
Current line alarms
Channel configuration:
channel = 1, path = oc1, hierarchy = 1/1/1/1, current path alarms: none
ifAdminStatus: up
snmp trap link-status: disabled
alarms used for operational status calculation: LOP AIS
defect trigger soaking delay: 2500 milliseconds
c2 byte override 20
Operational Status: up
time since last status change: 00:05:37
Ds3 1, unchannelized
ifOperStatus = ifOperUp
snmp trap link-status = disabled
Framing is C-BIT, Line Code is B3ZS, Clock Source is Internal - Module
See show controllers sonet.
Use to display E1 or T1 (DS1) statistics for the different layers in channelized
SONET and SDH interfaces. Figure 8 on page 113 shows the layers in the interface.
For definitions of the MIB statistics, see RFC 2495 Definitions of Managed
Objects for the DS1, E1, DS2 and E2 Interface Types (January 1999).
Specify an interface in slot/port format.
To view information for a specific controller in a layer, enter the specifier for the
controller and the type for the controller. For example, to view the E1 controller
1/1/1 on path 1 on the interface 4/0, enter show controllers sonet 4/0:1/1/1/1
e1.
To view information for all controllers above a particular layer, enter the specifier
for the layer and the type for the controller. For example, to view all E1 controllers
on the interface 4/0 path 1, enter show controllers sonet 4/0:1 e1.
To view E1 or T1 statistics for a layer, specify the controller type, e1 or ds1.
To view the configuration for a controller or all controllers in a layer, omit the
controller type.
Field descriptions
Chapter 4: Configuring Channelized OCx/STMx Interfaces
: none
Monitoring Interfaces
159