JUNOSe 10.0.x Physical Layer Configuration Guide
5.
6.
7.
t1 fdl
t1 fdl carrier
t1 fdl string
18
Configuration Tasks
host1(config-controll)#t1 1 fdl string port 0800
host1(config-controll)#t1 1 fdl string generator "Test generator"
Enable transmission of FDL messages.
host1(config-controll)#t1 1 fdl transmit path-id
(Optional) Specify that the router should generate yellow alarms for the T1
channels.
host1(config-controll)#t1 1 yellow generate
(Optional) Specify that the router should detect yellow alarms for the T1 channels.
host1(config-controll)#t1 1 yellow detect
Use to specify the FDL standard for the channel.
Specify one or more T1 channels or a range of channels in the range 1–28.
Specify the keyword ansi to support the ANSI FDL standard (see "References"
on page 9).
Specify the keyword att to support the AT&T FDL standard (see "References"
on page 9).
Specify the keyword all to support both the ANSI and AT&T standards
Specify the keyword none to remove the current FDL mode settings
You can configure a different standard on each T1 channel.
Example
host1(config-controll)#t1 14-20,24 fdl att
Use the no version to restore the default, none.
See t1 fdl.
Use to specify that T1 channels are used in the carrier environment.
Example
host1(config-controll)#t1 6 fdl carrier
Use the no version to restore the default situation, in which the T1 channels do
not operate in the carrier environment.
See t1 fdl carrier.