Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 97

Unavailable seconds Number of unavailable seconds encountered by a T3
in the current interval
Invalid seconds Number of seconds when statistics were not collected
Example This example specifies a T3 interface.
host1#show controllers t3 5/0 remote
Far End MDL Carrier bit is not set
Far End Equipment Identification Code is the null string
Far End Line Identification Code is the null string
Far End Frame Identification Code is the null string
Far End Unit Identification Code is the null string
Far End Facility Identification Code is the null string
Far End Generator Number is the null string
Far End Port Number is the null string
Number of valid interval - 3
Time elapse in current interval - 756
Ds3 Current Interval Counters
C-bit errored seconds
C-bit severely errored seconds = 0
C-bit coding violations
Unavailable seconds
Invalid seconds
Ds3 Last Interval Counters
C-bit errored seconds
C-bit severely errored seconds = 0
C-bit coding violations
Unavailable seconds
Invalid seconds
Ds3 24 Hour Total Counters
C-bit errored seconds
C-bit severely errored seconds = 1
C-bit coding violations
Unavailable seconds
Invalid seconds
See show controllers t3 remote.
Chapter 2: Configuring T3 and E3 Interfaces
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 1
= 330
= 0
= 0
Monitoring Interfaces
71