Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 42

JUNOSe 10.0.x Physical Layer Configuration Guide
t1 framing
t1 shutdown
t1 snmp trap link-status
16
Configuration Tasks
Use "show controllers t3" on page 30 to display the text description.
Examples
host1(config-controll)#t1 2 description london t1 interface
host1(config-controll)#t1 2/1 description london first ft1 interface
Use the no version to remove the text description or alias.
See t1 description.
Use to configure the framing format for T1 channels.
You must specify either esf (extended superframe) or sf (superframe) framing.
The framing format you choose must be compatible with the framing format at
the other end of the line.
Example
host1(config-controll)#t1 2 framing sf
Use the no version to restore the default value, esf.
See t1 framing.
Use to disable T1 channels or a subchannel.
To disable channels or a subchannel, specify one or more T1 channels or a
subchannel in channel or channel/subchannel format.
channel One or more T1 channels, or a range of channels in the range 1–28
subchannel Subchannel from 1–24
The T1 interface is enabled by default.
Example
host1(config-controll)#t1 4-15,18,21,25-27 shutdown
Use the no version to restart a disabled interface.
See t1 shutdown.
Use to enable SNMP link status processing on T1 channels.
To enable or disable SNMP on an interface, specify T1 channels or subchannel
in channel or channel/subchannel format.
channel One or more T1 channels, or a range of channels in the range 1–28
subchannel Subchannel from 1–24
Example