Juniper JUNOSE 10.0.X PHYSICAL LAYER Configuration Manual page 114

JUNOSe 10.0.x Physical Layer Configuration Guide
path trigger alarm prdi
path trigger delay
sdh
shutdown
88
Configuration Tasks
host1(config-controll)#path snmp trap link-status
Use the no version to disable SNMP link status processing.
See path snmp trap link-status.
Use to configure the router to use remote defect indications (RDIs) at the path
layer to determine the operational status of a path.
Do not specify a path identifier for unchannelized SONET/SDH interfaces.
Example
host1(config-controll)#path trigger alarm prdi
Use the no version to restore the default setting, in which the software uses loss
of pointer and AIS defects at the path layer to determine the operational status
of a path.
See path trigger alarm prdi.
Use to set the time that the router waits to set an alarm when the router records
a defect at the path layer.
Change this value from the default only when you are using MPLS fast reroute
over a SONET/SDH interface.
Specify a value of 0 milliseconds if the interface does not use APS/MSP or if
you want MPLS to have priority over APS/MSP.
Specify a value of at least 100 milliseconds if this interface uses APS/MSP
and you want APS/MSP to have priority over MPLS.
Do not specify a path identifier for unchannelized SONET/SDH interfaces.
Example
host1(config-controll)#path trigger delay msec 1000
Use the no version to restore the default setting, 2500 milliseconds.
See path trigger delay.
Use to specify that the interface supports SDH.
Example
host1(config-controller)#sdh
Use the no version to revert to SONET operation on this interface.
See sdh.