Table of Contents
Advertisement
idle-character
interface serial
invert data
load-interval
Use the no version to restore the default value, 16.
See crc.
Use to configure the HDLC idle character.
The idle character is sent between HDLC packets.
Specify one of the following idle characters:
flags—Sets the idle character to 0x7E
marks Sets the idle character to 0xFF
Example
host1(config-if)#idle-character marks
Use the no version to restore the default value, 0x7E (flags).
See idle-character.
Use to configure a serial interface in the slot/port:channel/subchannel format.
slot Number of the slot in which the line module resides in the chassis
port Number of the port on the I/O module
channel T1 channel
subchannel Subchannel in the range 1–24
Example
host1(config)#interface serial 0/1:1/5
Use the no version to disable the interface.
See interface serial.
Use to enable data stream inversion for the interface.
Enable data stream inversion only if it is turned on at the other end of the line.
Example
host1(config-if)#invert data
Use the no version to disable data inversion.
See invert data.
Chapter 1: Configuring Channelized T3 Interfaces
Configuration Tasks
21
Advertisement
Table of Contents
