Table of Contents
Advertisement
snmp trap link-status—Status of SNMP trapping (enabled or disabled)
alarms detected One of the following T3 alarms:
No alarm present No alarms present on the line
Rcv RAI Failure Remote device is sending a far end alarm failure
Xmt RAI Failure Local device is sending a far end alarm failure
Rcv AIS Remote device is sending an alarm indication signal (AIS)
Xmt AIS Local device is sending an AIS
Rcv LOF Loss of one or more frames from the remote end
Rcv LOS Loss of signal at the local end
Undefined line status Indicates that the line is in an undefined state
NOTE: The alarms detected field does not appear for interfaces that you disabled in
the software.
framing Type of framing format
line code Type of line code format
clock source Type of clock source
cable length Cable length, in feet
Loopback State of loopback for the controller: enabled or disabled. If
loopback is enabled, one of the following states is displayed:
Diagnostic Loops the data back toward the router and sends an AIS
toward the network
Payload Loops the data toward the network after the framer has
processed the data
Line Loops the data toward the network before the data reaches the
framer
MDL Transmit Path Status of path transmission: active or not active
MDL Transmit Test-Signal Status of test signal: active or not active
MDL Transmit Idle-Signal Status of idle signal: active or not active
Equipment Identification Code eic string for MDL
Line Identification Code lic string for MDL
Frame Identification Code fic string for MDL
Unit Identification Code unit string for MDL
Chapter 1: Configuring Channelized T3 Interfaces
Monitoring Interfaces
31
Advertisement
Table of Contents
