Radius - D-Link KVM-410 - Single Port KVM Switch User Manual

Section  - Admin Programs
The KVM-410 supports the use of a RADIUS server for user authentication. The RADIUS page contains the parameters
to configure the KVM-410 RADIUS authentication.
1. Check Enable in the RADIUS dialog box.
2. Fill in the IP Address and Service Ports for the Primary and
Alternate RADIUS Servers.
3. In the Timeout (seconds) field, set the time that the KVM-410
waits for a RADIUS Sever reply before it will time out.
4. In the Retries field, set the number of times to retry RADIUS
authentication.
5. In the Shared Secret field, enter the shared secret that the
KVM-410 will use to authenticate on the RADIUS server.
6. On the RADIUS Server, set the access rights for each user
according to the information on the table below:
D-Link KVM-410 User Manual

RADIUS