Filtering - D-Link KVM-410 - Single Port KVM Switch User Manual

Section  - Admin Programs
There are a maximum of 100 filters allowed for each category: User IP Address; User MAC Address; and Admin
Station Filters. User Station filtered addresses (IPs and MACs) can be allowed or denied by highlighting the item
and clicking the include or exclude radio buttons. Checking include will only allow all the addresses in the filter
range to access the KVM-410, while exclude will deny access to all the addresses in the filter range.
To enable IP filtering for User Stations, Click the IP Filter Enable check box so
a check mark appears.
To add a Filter:
1. Select whether the Filter will include or exclude specified User Stations.
2. Click Add. An IP Filter dialog box will appear:
3. Specify the IP Addresses to be filtered, then Click OK. Each IP
Filter can consist of a single address, or a range of addresses.
4. To filter a single IP Address, enter the same To IP Address as the
From IP Address. To filter a range of addresses, enter the last IP
Address of the range. Click OK.
5. Repeat these steps for any additional IP Addresses or ranges or addresses you want to filter.
D-Link KVM-410 User Manual

Filtering

User Station Filtering - IP Address
4