Radius - D-Link KVM-410 - Single Port KVM Switch User Manual

Section  - Configuration
The KVM-410 supports the use of a RADIUS server for user authentication. The RADIUS page contains the parameters
to configure the KVM-410 RADIUS authentication.
1. Check Enable in the RADIUS dialog
box.
2. Fill in the IP Address and Service Ports
for the Primary and Alternate RADIUS
Servers.
3. In the Timeout field, set the time that the
KVM-410 waits for a RADIUS Sever reply
before it will time out.
4. In the Retries field, set the number of
times to retry RADIUS authentication.
5. In the Shared Secret field, enter the shared secret that the KVM-410 will use to authenticate on the RADIUS
server.
D-Link KVM-410 User Manual

RADIUS

4