Assigning Roles - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM ADMINISTRATION REFERENCE 10.3 16-04-2010 System Administration Manual

The most restrictive right set in ZENworks prevails. If you select the Deny option, the right is
denied for any administrator assigned to that role, even if the administrator is granted that right
elsewhere in ZENworks.
If you select the Allow option and the right has not been denied elsewhere in ZENworks, the
administrator has that right for the role.
If you select the Unset option, the administrator is not granted the right for the role unless it is
granted elsewhere in ZENworks.
5 Click OK to continue.
6 To add another rights type to the role, repeat
7 Click OK to exit the Add New Role dialog box.
The role is now displayed in the Roles panel. To assign it to administrators, see
"Assigning Roles," on page

2.4.3 Assigning Roles

You can assign roles to administrators, or administrators to roles:
"Assigning Roles to Administrators" on page 47
"Assigning Administrators to Roles" on page 49
Assigning Roles to Administrators
Rights can be set in multiple locations in ZENworks Control Center, including for administrators.
Administrators can be assigned to multiple roles.
If an administrator has rights conflicts because different conditions are set for a particular right in
ZENworks Control Center, the Deny option is used if it is set anywhere for the administrator. In
other words, Deny always supersedes Allow when there are rights conflicts.
To assign roles to an administrator:
1 In ZENworks Control Center, click Configuration in the left pane, click the Configuration tab,
then in the Administrators panel, click an administrator name in the Name column to open the
administrator's settings page:
Step 3 through
47.
Step 5.
Section 2.4.3,
Administrators 47