Reboot Behavior - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM ADMINISTRATION REFERENCE 10.3 16-04-2010 System Administration Manual

3 Select the Stage Timeout check box, then specify the days, hours, and minutes desired.
4 Click Apply to make the changes effective.
5 Either click OK to close the page, or continue with
If you did not click Apply to make your changes effective, clicking OK does so. Clicking
Cancel also closes the page, but loses your unapplied changes.

20.1.7 Reboot Behavior

Some updates do not require a device to be rebooted after they have been deployed to a device.
However, if a reboot is required to complete the update process, the deployment is not completed
until the device is rebooted.
To configure the reboot behavior:
1 In ZENworks Control Center, click Configuration in the left pane.
2 On the Configuration tab, expand the Management Zone Settings panel (if necessary), click
Infrastructure Management, then click System Update Settings to display the Reboot Behavior
panel:
3 Select one of the following options:
Prompt User to Reboot When Update Finishes Applying (Default): After the update
has been applied, a request to reboot is immediately displayed. If the user initially rejects
rebooting, the user is periodically requested to reboot the device, until the device is
rebooted.
Do Not Reboot Device: The device does not reboot; however, the user is periodically
requested to reboot the device, until the device is rebooted.
Force Device to Reboot: After the update has been applied, the device is automatically
rebooted without user intervention if a reboot is required by the update.
4 Click Apply to make the changes effective.
5 Either click OK to close the page, or continue with
If you did not click Apply to make some of your changes effective, clicking OK does so.
Clicking Cancel also closes the page, but loses your unapplied changes.
another configuration task.
another configuration task.
Configuring Updates 181