Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM ADMINISTRATION REFERENCE 10.3 16-04-2010 System Administration Manual page 238

2 Because an empty
(
installation_path\zenworks\work\content-repo
repository location, do one of the following to make sure that there is no content in the default
location:
If you need to save the content that is now in this directory, rename the existing directory
and create a new directory named
You can later copy the content from this renamed directory to the new content repository
location (see
If you do not need any of the content in the existing
directory and re-create it.
If the
directory.
3 Click Start, right-click the My Computer icon, then select Manage.
You can also click Start, then enter
4 Select Disk Management under the Storage section in the left pane.
The disk drive you selected in
5 (Conditional) If a driver letter is associated with the partition that you want to use as the new
content repository location, do the following:
5a In the Computer Management dialog box, right-click the drive's partition.
5b Select Change Drive Letter and Paths.
5c Select the drive letter.
5d Click Remove, then select Yes to confirm.
6 Right-click the partition of the disk drive that you want to use as your content repository, then
select Change Driver Letter and Paths.
This is the disk drive that you will mount to the
7 Click Add.
This displays the Add Drive Letter or Path dialog box.
8 Select Mount in the Following Empty NTFS Folder, browse for and select the default
content-repo
The default directory is
This mounts the default path to the hard drive partition that you selected in
If necessary, format the drive as NTFS using the Computer Management feature in Windows.
9 Click the buttons as necessary to exit and save the configuration change.
10 (Conditional; see
new
content-repo
From this point on, all ZENworks 10 Configuration Management data is written directly to the new
content repository location on the selected hard drive partition.
238 ZENworks 10 Configuration Management System Administration Reference
directory must exist in the default location
content-repo
Step 10).
directory is not present in the path given above, create the path and
content-repo
compmgmt.msc
Step 1
directory, then click Next.
installation_path\zenworks\work\content-repo
Step 2) Copy the files from the old renamed
directory.
) to be the pointer to the new content
.
content-repo
content-repo
at the Run command line.
should be displayed in the right pane.
content-repo
content-repo
directory, delete the
directory in Step 8.
.
Step 6.
directory to the