Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM ADMINISTRATION REFERENCE 10.3 16-04-2010 System Administration Manual page 346

Select the Days of the Week and the Time to Perform the Message Cleanup: Allows you
to specify the time and the days of the week to run the Message Cleanup action. The
administrator can set a daily schedule for Message Cleanup action.
Use Coordinated Universal Time: Allows you to convert the specified time to UTC (GMT)
time. By default, this option is selected.
4 In the E-mail Notification panel, configure the settings to send the error messages to the
administrators through e-mail:
Send Log Message via E-mail if Severity Is: Allows you to select the severity of the message
to trigger sending the log messages through e-mail.
From: Specify the sender's e-mail address.
To: Specify the e-mail address of the recipients. You can specify more than one e-mail address
by separating them with commas.
Subject: Specify the subject to be included while sending the e-mail from the Primary Server.
You can customize the Subject field with macro values. For more information on customizing
the subject field, see
5 In the SNMP Traps panel, configure the SNMP traps on the ZENworks Server to send log
messages:
Send as SNMP Trap if Severity Is: Sends an SNMP trap if the logged message's severity is
Error.
Trap Target: Specify the IP address or DNS name of the SNMP server.
Port: Specify the port number of the SNMP server configured for this operation. By default,
the port number is 162.
Community String: Specify the community string of the SNMP trap that is to be sent.
6 In the UDP Forwarder panel, configure the settings to send logged messages through the UDP
services. The following table contains information on the options available:
Send Message via UDP: Sends messages to the UDP destinations if the logged message's
severity is Error.
UDP Destinations: You can perform the following tasks with the Add, Edit, and Remove
options:
Add a Server
Remove a Server
Edit Server Details
346 ZENworks 10 Configuration Management System Administration Reference
Section 39.1.2, "E-Mail Format," on page
1. Click Add to display the Add UDP Destination Address dialog box.
2. Specify the server name and the UDP port number configured for this operation.
3. Click OK.
1. Select the check box next to the server (or servers).
2. Click Remove.
1. Select the check box next to the server.
2. Click Edit to display the Edit UDP Destination dialog box.
3. Modify the settings as desired, then click OK.
350.